If you’re using your iPhone to listen to music but not with AirPods or to use the call feature via a speaker, you’d like it to sound as straightforward as possible. But, the iPhone’s speaker may express less clearly or as high-quality as before.
As with cleaning AirPods, you could also cleanse your phone’s speakers located at the lower part of the screen. The reasons your speakers may sound less good are becoming blocked by dust or particles with time.
If you’d like to boost the audio quality of your device, we’ll help you learn how to cleanse the iPhone speakers in the following article.
How can you properly clean the iPhone’s speakers without damaging the speakers?
Cleansing iPhone speaker with the help of a gentle brush
The easiest way to eliminate small pieces of dust or dirt off the speaker at the back of the iPhone is by using an instrument with soft bristles, ideally a smaller paintbrush. You can cut the strands to a half-inch length to give you more control.
Gently sweep the speaker from top to bottom and then move through the thin, long speaker multiple times. Ensure the brush is not dragging along the center that runs through the speakers. It is also possible to work the soft bristles through the holes inside the telephone’s base.
Cleansing iPhone speaker with an instrument like a toothpick
When bits of debris have gotten stuck inside the holes for speakers at the lower part of the iPhone, You can use the sharp edge of a wood or plastic toothpick to break them up. Inject the tip using only a little pressure and gradually tilt it until it pops up. The force must be directed to the side and later upwards and not towards the phone.
Utilize an Air Blower to clean iPhone Speakers.
Instead of putting compressed air into containers, utilize an air blower to blast dust off your iPhone. It’s much more secure because air blowers are soft yet exert a force sufficient to lift dust.
Here are a few tips to remember when working with an air compressor
Keep the air compressor near the screen of your iPhone and then blow it a few small bursts of air directly to the speaker. Even though it’s not as robust as compressed air, it will quickly remove dirt and dust and not push it into the speaker.
To enhance the effect, you can move the blower’s air closer to the speaker and close to it.
Utilize a flashlight to determine whether you have removed all the dust. If you need help, go through the steps.
Painter’s tape is a good choice.
Masking or painter’s tap is a different sticky item that can be used to get rid of dirt on the speaker. Masking tape works since it’s less durable than other varieties of sticky tape. Additionally, it doesn’t leave any residue of glue on the surface of your iPhone.
Cover a tiny piece of painter’s adhesive around yourself or your finger with the sticky sides out. Put the tape on the speaker you are listening to and then turn it from one side to another. Dust will accumulate without pressing it with a lot of force. Repeat the roll many times, then use an LED to see the progression.
Improve Sound Quality
Cleansing the iPhone speakers will improve audio quality. If, however, something’s going on with the sound, even if you’ve cleaned both speakers, send your iPhone for a check-up by a specialist. Visit the closest Apple repair service because something could be blocking the sound.
An easy way to test the audio quality for the iPhone after cleaning your speakers is by opening your Settings app. Depending on the iPhone model, go into Sounds and Haptics or Sounds & Haptics. Then, locate the Ringer and the Alerts slider and slide it up and down. The phone should sound the ringtone tone at different volumes. If the sound doesn’t seem right, your iPhone may require further repair.
The “don’ts” for cleaning your iPhone speakers
Before you contemplate what tools you’ll need, or reach for something that may cause damage to your costly smartphone, Here are some things you should never make.
Avoid using any sharp object in an attempt to slash away any gunk. It has been suggested to use the short ends of tweezers, toothpicks, or even paper clips to scratch the grills of your speakers. Don’t.
Avoid using rubbing alcohol or any liquid. Although rubbing alcohol evaporates faster than water, all kinds of juice and the internals of smartphones aren’t the best combinations.
Do not use canned or compressed air. Although these are great for cleaning electronics with a lot of power for laptop keyboards, the force generated is far too powerful for delicate electronic devices. The result could be pushing dirt more profoundly into the machine.
Maintaining Your iPhone Clean
Clean the iPhone speakers to prevent the quality of sound or muffled problems. As you clean, utilize a bright flashlight to light the region of the phone you’re cleaning so that you can ensure the holes in your speakers are free of debris and dust.
If you’re iPhone isn’t clear enough or not distorted enough, It could be due to an issue with the software. Start your iPhone to see if this solves the problem.
Apart from iPhone speakers, ensuring that your other devices are in good condition is essential. In particular, you’ll need to learn how to wash AirPods and their case when you have one. You should know how to clean your HomePod and HomePod Mini for other Apple gadgets.
Cleansing your tech gadgets is vital. Look at the proper way to take care of your phone when you own an iPhone or Android.
Another gadget you don’t be thinking about, but which is equally vital, is cleaning the Chromebook screen. For other devices, look at our guides to clean your various other gadgets.